Suggested hardware to attach your
PRE-VENT® Feeder in a stall:
• (3) 3/8” eye bolts
• (6) 3/8” nuts
• (6) 3/8” flat washers
• (3) 3/8” lock washers
• (3) 5/16” spring clips
• (3) 5/16” eye screws |
 |
 |
Step 1. Attach your 3 eye bolts with corresponding hardware to your PRE-VENT® Feeder:
|
|
 |
|
|
|
Step
2.
In
preferred
corner
of
stall,
push
shavings
to
the
side
for
an
accurate
measurement.
Measure
from
floor
upwards
30”
-
32”
mark
stall
with
pencil.
|
|
|
|
| Step 3. Now, measure to the left or right (preference) 4” - 6” and again mark stall with pencil. The intersection of these two measurements is your center eye screw location. |
|
|
|
|
| Step 4. Now drill a pilot hole (a pre-drilled hole to prevent wood from splintering and to ease the installation off said hardware) with and 1/8”-3/16”drill bit. Install eye screw and attach spring clip from eye bolt to eye screw. |
|
|
|
|
| Step 5. For the left and right eye screw locations measure up from floor 28” - 30” (about 2” lower than middle eye screw) mark stall with pencil. Now measure from the corner to the left and right 22” - 24” and mark stall with pencil. The intersections of these two marks are your left and right eye screw mounting locations. |
|
|
|
|
Step 6. Drill your pilot holes for those second two eye screws. Install both left and right eye screws. Connect your spring clips and your PRE-VENT® Feeder is now ready to use! |
|
 |
|
|
|
Notice that
the front of
the PRE-VENT®
Feeder is
slightly
tilted
forward.
This is on
purpose as
it allows
the horse’s
large head
and rounded
jaw more
access to
his favorite
stuff…food!! |
|
|
 |
Here is a properly attached
feeder in a stall. |
|
|
The PRE-VENT® Feeder is meant to attach in the corner of a stall, which is the part of the stall the horse typically doesn’t use. You can replace your corner feeder with the PRE-VENT® Feeder…it takes up about the same amount of space.
Feed your horse the healthy way…the
PRE-VENT® way! |
 |
|
Note: For concrete stall/ galvanized pipe fencing or any installation questions contact Hal@PRE-VENTfeeders.com. Most installation questions can be solved with a picture and a brief explanation via e-mail. |
Download Instructions |
|
Hardware now available to order online. |
